Please take the time to get well acquainted with your vehicle by reading this handbook. Use a screwdriver to pry the spring clip on each connector past the head of the support screw. Do not use fuel lines, engine rocker covers or the intake manifold as grounding points. Remove the bulb socket from the foglamp by turning counterclockwise. Always set the parking brake fully and turn off the ignition when leaving the vehicle. Dry the area with a soft cloth.
The high-current fuses are coded as follows. To prevent the vehicle from moving when you change the tire, be sure that the parking brake is set and the diagonally opposite wheel is blocked. This transmission unit includes a transmission case, valve body, tail shaft and housing, torque converter automatic only , and all internal lubricated parts. During the operation of any selected mode, lighting for the individual function controls will either illuminate or turn off. The audio system automatically switches to single channel reception if it will improve the reception of a station normally received in stereo. Adjust spotter mirrors if equipped manually. Install the bulb socket in the foglamp by turning clockwise.
Connect the negative - cable to the negative - terminal of the assisting battery. Locate and carefully remove the engine oil level indicator dipstick. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. If equipped, remove tail lamp covers. Follow the instructions in this chapter. Mode selector control Controls the direction of the airflow to the inside of the vehicle.
Upshifts can be made by shifting to 2 Second or to Overdrive. Do not drive if you smell exhaust fumes. Speaker balance adjust Speaker sound distribution can be adjusted between the right and left speakers. Without turning, carefully pull bulb assembly out of headlamp assembly and replace. Return the head restraint to its original position. Remove the jumper cable from the ground metal surface. Route the child safety seat tether strap over the back of the seat.
Refer to the scheduled maintenance guide for the service interval schedules. Before placing the child in the seat, forcibly tilt the seat forward and back to make sure the seat is securely held in place. The purpose of these head restraints is to help limit head motion in the event of a rear collision. When the first six strong stations are filled, the station stored in memory preset control 1 will start playing. Starting from the opposite side of the vehicle, pull cover away from the side rail and roll the cover from rear to front. To raise the height of the shoulder belt, slide the height adjuster up. This system will disable the power door lock controls.
Each press will decrease the set speed by 1. If you use a rental trailer, follow the instructions that the rental agency gives to you. The display should show the current zone number. Make sure the parking brake is fully set. Booster seats position a child so that safety belts fit better. Hold the steering wheel firmly and slowly move to a safe place on the side of the road. Disengaging the speed control will not erase the previously programmed set speed.
Refer to Tune adjust or Seek function for more information on selecting a station. These can be harmful and compromise the corrosion protection of the engine coolant. Speed sensitive volume if equipped With this feature, radio volume automatically changes slightly with vehicle speed to compensate for road and wind noise. When in this position rotate the control upward for fast intervals and downward for slow intervals. Pull control to release seat. Check the fuel system for leaks.
Hold the control to continue reversing through the discs. Refer to Motorcraft Part Numbers. The red indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. For additional information, refer to the Driving with a 4—speed automatic transmission section in this chapter. The correct bulbs will not damage the lamp assembly or void the lamp assembly warranty and will provide quality bulb burn time.
Wait until the safety belt warning light turns off. For more information on top tether straps, refer to Attaching safety seats with tether straps. Refer to Turning speakers on and off. Turn the control to raise or lower volume. A danger lies in losing traction, slipping sideways and possibly rolling over. Gasoline may contain benzene, which is a cancer-causing agent.